-
Notifications
You must be signed in to change notification settings - Fork 0
Corner
Leon Starr edited this page Jan 14, 2025
·
1 revision
This is a point on the Canvas where two lines of a Bending Binary Connector meet at a right angle. Corners are not specified by the user, they are computed from user specified anchor positions and Paths.
- Location
No two corners may overlap
- Location + Connector
(super identifier to support R111 )
The computed Canvas x and y coordinate of the Corner
Type: Position
Copyright © 2021 and 2025, Leon Starr at Model Integration, LLC under the MIT Open Source License