How is the bootloader for the Bridge configured?

[gbraad]

I wanted to add a TFT display to the board to allow it to be used as an Arcade target with output on the display, however at the moment I am unable to find any pin mapping, and not sure how the bootloader is configured. Eg. is DISPLAY_TYPE=9341 set for the bootloader?

[gbraad]

@xmeow Any thoughts?

[gbraad]

https://github.com/gbraad/kittenbot-bridge/blob/master/configuration.md

PINS_PORT_SIZE = PA_32
PIN_A0 = PA02
PIN_A1 = PA05
PIN_A2 = PA06
PIN_A3 = PA04
PIN_A4 = PB08
PIN_A5 = PB09
PIN_D0 = PA23
PIN_D1 = PA22
PIN_D2 = PB17
PIN_D3 = PB16
PIN_D4 = PB13
PIN_D5 = PB14
PIN_D6 = PB15
PIN_D6 = PB12
PIN_D6 = PA02
PIN_D9 = PA20
PIN_D10 = PA18
PIN_D11 = PA19
PIN_D12 = PA17
PIN_D13 = PA23
PIN_MISO = PA14
PIN_MOSI = PA12
PIN_RX = PA23
PIN_SCK = PA13
PIN_SCL = PB03
PIN_SDA = PB02
PIN_TX = PA22
PIN_ACCELEROMETER_INT = PB01
PIN_BTN_A = PIN_D11
PIN_BTN_B = PIN_D12
PIN_BTN_DOWN = P_1241
PIN_BTN_LEFT = P_1240
PIN_BTN_MENU = PIN_D10
PIN_BTN_RIGHT = P_1140
PIN_BTN_UP = P_1141
PIN_DISPLAY_BL = PIN_D5
PIN_DISPLAY_CS = PB12
PIN_DISPLAY_DC = PIN_D3
PIN_DISPLAY_MOSI = PIN_D6
PIN_DISPLAY_RST = PIN_D2
PIN_DISPLAY_SCK = PIN_D4
PIN_LED = PA16
PIN_LIGHT = PB00
PIN_NEOPIXEL = PB22
PIN_P0 = PIN_A0
PIN_P1 = PIN_A1
PIN_P2 = PIN_TX
PIN_P3 = PIN_A3
PIN_P4 = PIN_A4
PIN_P5 = PIN_A5
PIN_P6 = PIN_D6
PIN_P7 = PB12
PIN_P8 = PIN_A0
PIN_P9 = PIN_D9
PIN_P10 = PIN_RX
PIN_P11 = PIN_D11
PIN_P12 = PIN_D12
PIN_P13 = PIN_SCK
PIN_P14 = PIN_MISO
PIN_P15 = PIN_MOSI
PIN_P16 = PIN_D10
PIN_TEMPERATURE = PB05
ACCELEROMETER_TYPE = MPU6050
BOOTLOADER_BOARD_ID = 0x239a003d
DISPLAY_CFG0 = 0x80
DISPLAY_CFG1 = 0x12c2d
DISPLAY_CFG2 = 0x18
DISPLAY_HEIGHT = 128
DISPLAY_WIDTH = 160
FLASH_BYTES = 0x80000
NUM_NEOPIXELS = 1
RAM_BYTES = 0x30000
UF2_FAMILY = ATSAMD51

[gbraad]

https://github.com/gbraad/pxt-maker-kittenbot-bridge

Since this information is not upstream yet

[gbraad]

Also see #8